RESPICAL

CALIBRATION ANALYSER

For more than a decade, health care professionals have depended on the RT 200 for day to day-in-day-out performance.  Today, the workhorse RT200 has a worthy successor- The RespiCal by Allied Healthcare.  It offers so many new applications, it represents more of a revolution than an evolution.

Consider how the new enhanced capabilities of the RespiCal can help you in your task of providing equipment that is tested and ready to use without expensive down time or the need to relocate.

The unit is totally portable and weighs only 4.7 kg

In Stand alone mode the RespiCal can measure pressures, flows, volumes,  barometric pressure, gas concentration and voltage from many devices. 

The user can review up to three measurements simultaneously.  Plus, the operator uses only four keys to control the unit.

The RespiCal can plug into a PC above a 486 with a RS-232 socket running Windows 95 or 98 operating system.

When connected to a PC running the provided software it will display any two real time measurements simultaneously.  High pressure, low flow,  low pressure, high flow, gas concentration percentage or 0 to 10 volt external input or medical breath calculations.

When connected to a PC all information can be documented and stored electronically for reference or record keeping.

 
 
 

The RespiCal comes complete with manual, power cord,  software, small bore hoses, "T" pieces, filter, adaptors and computer RS 232 cable.

Other accessories available are Hard Plastic water tight transport case, additional large bore hoses, DISS nuts and tail pieces plus Australian Diameter indexed hoses and fittings. 
 
 

Respical gives biomed professionals a uniquely valuable tool to increase productivity and effectiveness.

  • Pressure measurements with three pressure transducers, including barometer reading 10 to 18 PSO, low pressure of -120 to +120 cm H2O and pressures from 0 to 100 PSIG

  • Flow measurement s with two mass flow sensors, one for high and one for low measurements of Oxygen Nitrogen and Air.

  • Software converts units to standard temperature and pressure (STP), ambient temperature and pressure (ATP) and body temperature and pressure saturated with water (BTPS)

  • Tidal volume measurements of a ventilator or similar device are updated every other breath.

  • Breaths per minute, inspiratory time, expiratory time and I:E ration are updated every other breath.

  • Analogue voltages measured from 0 to +10 volts

  • Operator-set digital filter with three settings to smooth signal transitions on pressure and flow meters.

  • Analogue signal output proportional to the selected pressure, flow or analogue voltage device.  Output scaled to provide a 0 to + signal.

  • Displays of gas temperature that allows the operator to compensate for temperatures in 1 degree increments.